**Currently en route to our facility. It will take about 30 days to arrive, after which we will test and certify it.**

Sanyo MCO-19AIC (UV) CO2 Incubator

Guaranteed to Perform Without Error
After your instrument arrives at our facility, it will be inspected and tested to verify that it is free of malfunction. Unless stated otherwise, we are confident it will perform at manufacturer specifications. If you receive this instrument and it does not meet your required specifications, your purchase will be protected by our warranty.

In Good Cosmetic Condition or Better
The photos on display are stock photos and do not directly represent the instrument you will receive. However, we guarantee your instrument will be in as good cosmetic condition or better when it arrives at your location. For reference, used equipment in good cosmetic condition commonly has a few scratches and scuffs present.

Included Items:
- Sanyo MCO-19AIC (UV) CO2 Incubator
- Power Cable

Specifications

Manufacturer	Sanyo
Model	MCO-19AIC
External dimensions	620 x 710 x 900 mm (W x D x H)
Internal dimensions	490 x 523x 665 mm (W x D x H)
Interior volume	170 L
Access port	Inner diameter: 30 mm, On the back side
Insulation	Rigid polyurethane foamed-in place
Heating system	DHA system (heater jacket + air jacket system)
Heater	314 W
Humidifying system	Natural evaporation with humidifying pan
Temperature controller	PID control system
Temperature display	Digital display
CO2 controller	PID control system
CO2 density display	Digital display
Air circulation	Fan assisted
Temperature control range	+5°C above ambient to 50°C (in a 5°C to 35°C ambient).
Temperature control uniformity	±0.25°C in 25°C ambient, setting 37°C, 5% CO2, no load.
C02 control range and deviation	0% to 20%, ±0.15% in 25°C ambient, setting 37°C, 5% CO2, no load.
C02 sensor platform	Ceramic based, single beam Infrared sensor, with dual wavelength measurement for continuous auto-zero calibration
Air filter	0.3 Pm, Efficiency: 99.97% or higher
UV lamp	4W X 1 (ozone-free emission)
Water level sensor	Optical
Alarms	Automatic set temperature alarm, Automatic set CO2 density alarm, Upper limit temperature alarm, Door alarm, Low humidifying water alarm, UV lamp failure alarm (for UV equipped model only)
Remote alarm contacts	Allowable contact capacity: 30 VDC, 2 A
CO2 inlet connection	4 to 6 mm diameter tube
CO2 inlet pressure	0.03 MPaG (0.3 kgf/cm2 G, 4.3 psiG)
Weight	93 kg

Sanyo

Filter By

Price Range

Listing Type

Condition

Category

Manufacturer